Publicidad
i. INSTALLATION
Raise the swivel case assembly to the uppermost position.
1) When the lower cylinder bushings have been removed from the power trim/tilt assembly, apply marine grease to the
1
outer surface of the new lower cylinder bushings and install them on the power trim/tilt assembly.
2) Pass the power tilt motor wire and the trim angle sensor wire through the hole in the L. stern bracket.
2
3) Apply marine grease to the outer surface of the 10 mm distance collar and to the entire surface of the 19.4 x 6 mm
3
spacer.
Raise the L. stern bracket and install the 10 mm distance collar of the power trim/tilt assembly in the L./R. stern
4
brackets.
4) Install the 10 x 158 mm hex bolt and the 10 mm washer, and loosely tighten the 10 mm self-locking nut.
5
• Loosely tighten the 10 mm self-locking nut so it does not come out of the 10 x 158 mm hex bolt.
6
7
[1]
10 x 158 mm HEX
BOLT
8
9
10
[9]
11
L. STERN BRACKET
12
13
14
15
[8]
16
10 mm WASHER
17
18
[7]
10 mm SELF-LOCKING
19
NUT
20
14-39
[6]
(MARINE
GREASE)
496
[2]
LOWER CYLINDER
BUSHING (2)
[3]
POWER TRIM/TILT
ASSEMBLY
[4]
10 mm DISTANCE
COLLAR
[5] 19.4 x 6 mm SPACER
Publicidad
Capítulos
