Publicidad
9) Remove the 6 x 12 mm flange bolt from the connector bracket, and remove the harness and the connector bracket
as a set from the tiller handle assembly.
1
Remove the harness band clip, which clamps the tube A, from the connector bracket.
2
10) Remove the warning buzzer from the housing.
3
4
5
[1]
COMBINATION
6
SWITCH
7
8
9
[8]
10
40 mm CORD
TUBE
11
12
13
14
[7]
WARNING
BUZZER
15
16
17
11) Open the harness band clip that clamps the 40 mm cord
tube.
18
Replace the harness band clip with a new one on
reassembly.
19
Remove all the connectors from the 40 mm cord tube.
20
Disconnect the four meter harness connectors [Equipped
type only] (P. 16-38).
16-11
6 x 12
[4]
HARNESS BAND
CLIP (2)
[2]
40 mm CORD
TUBE
[3]
CONNECTOR
580
[2]
EMERGENCY STOP
SWITCH
[3]
TUBE A
[5]
CONNECTOR
BRACKET
[6]
HOUSING
[1]
HARNESS
BAND CLIP
Publicidad
Capítulos
