Publicidad
18) Route the trim angle sensor wire through the cutout in the
electric part case.
1
While pulling the main wire harness toward you, route the
trim angle sensor wire between the electric part case and
2
the main wire harness.
• Route the trim angle sensor wire on your side of the
3
power tilt relay B terminal wire.
4
Set the trim angle sensor wire in the clamps of the electric
part case.
5
Connect the trim angle sensor 3P connector, and install it
on the electric part case.
6
7
8
9
10
11
12
19) Install the harness band clip of the main wire harness on
13
the electric part case.
14
Install the DLC (data link connector) on the fuse box
bracket.
15
16
17
18
19
20
14-43
[1] ELECTRIC PART
CASE
[6] POWER TILT RELAY
B TERMINAL WIRE
[1] FUSE BOX
BRACKET
[5] DLC (DATA LINK
CONNECTOR)
504
[2] CLAMPS
[3]
TRIM ANGLE
SENSOR
3P CONNECTOR
[2] CLAMPS
[4] MAIN WIRE
HARNESS
[5] CUTOUT
[2] ELECTRIC PART
CASE
[3] HARNESS
BAND CLIP
[4] MAIN WIRE
HARNESS
Publicidad
Capítulos
