Publicidad
7) Install a new pinion gear shim in the gear case assembly.
• When the gear case, vertical shaft or the bearing is
1
replaced with a new one, perform shim adjustment and
select the appropriate shim accordingly (P. 11-40).
2
8) Apply gear oil to the outer surface of the new bearing
[outer race].
3
9) Drive the 25 x 47 x 15 mm bearing [outer race] into the gear
4
case assembly using the special tools as shown.
5
• Install the bearing [outer race] with the larger I.D. side
toward the water pump housing.
6
TOOLS:
Driver
7
Attachment, 42 x 47 mm
8
9
10
11
12
10) Apply gear oil to the inner wall and roller of the bearing
13
[inner race]. Install the 32 x 58 x 17 mm bearing [inner race]
on the forward bevel gear.
14
11) Install the forward bevel gear/bearing assembly in the gear
15
case assembly.
16
17
18
19
20
11-36
[1]
DRIVER
07749-0010000
07749-0010000
07746-0010300
[4] 25 x 47 x 15 mm
BEARING
[OUTER RACE]
[1]
GEAR CASE ASSEMBLY
[3] 32 x 58 x 17 mm BEARING
[INNER RACE]
292
[2]
ATTACHMENT,
42 x 47 mm
07746-0010300
[3]
PINION GEAR
SHIM
[2]
FORWARD
BEVEL GEAR
Publicidad
Capítulos
