Publicidad
12. OIL CASE
1
a. REMOVAL
- Engine cover (P. 4-2)
- Gear case assembly/extension separator [Semi-long/extra-long shaft types only] (P. 11-3)
2
- Extension case/lower rubber mount (P. 11-48)
1) Drain the engine oil from the oil case (P. 3-4)
3
2) Remove the two 8 x 25 mm flange bolts, and remove the exhaust pipe and exhaust pipe gasket.
4
3) Disconnect the water tube from the oil case, and remove the water tube grommet from the oil case.
5
4) Remove the eleven 6 x 25 mm flange bolts, and remove the oil case from the primary gear case.
6
7
8
9
10
11
12
13
[12]
14
13.8 x 2.5 mm
O-RING
Do not reuse.
15
[11]
16
OIL STRAINER
17
[10]
O-RING
18
Do not reuse.
19
[9]
EXHAUST PIPE
20
GASKET
Do not reuse.
[8]
WATER TUBE
GROMMET
[7]
WATER TUBE
11-56
[1]
OIL LEVEL GAUGE
[2]
OIL CASE GASKET
Do not reuse.
6 x 16 (2)
13 N . m (1.3 kgf . m, 10 lbf . ft)
332
[3]
OIL CASE
[4]
12 mm DRAIN
PLUG WASHER
Do not reuse.
[5]
OIL DRAIN PLUG BOLT
23 N . m (2.3 kgf . m,
17 lbf . ft)
6 x 25 (11)
10 N . m (1.0 kgf . m,
7 lbf . ft)
8 x 25 (2)
26.5 N . m (2.7 kgf . m,
20 lbf . ft)
[6]
EXHAUST PIPE
Publicidad
Capítulos
