Publicidad
3) Open the tie-wrap band and the harness band clips to
release the motor wire.
1
4) remove the four screw washers, and remove the power tilt
motor assembly and the motor wire bracket A.
2
See P. 14-46 for disassembly, inspection and reassembly of
the power tilt motor assembly.
3
5) Drain the ATF (automatic transmission fluid) from the gear
pump chamber.
4
6) Remove the O-ring from the power tilt motor assembly.
5
Replace the O-ring with a new one on reassembly.
7) Remove the drive joint from the gear pump assembly.
6
7
8
9
10
11
12
8) Hold the cylinder comp. in a vise using a shop towel or
13
equivalent material as shown.
14
NOTICE
Do not tighten the vise excessively, as it can damage the
15
cylinder comp.
16
17
18
19
20
14-9
[2] POWER TILT MOTOR
[1] MOTOR WIRE
BRACKET A
[8]
HARNESS
BAND CLIP (2)
436
[3] SCREW WASHER (4)
[4]
TIE-WRAP
BAND
[5] O-RING
[6]
DRIVE JOINT
[7]
GEAR PUMP
CHAMBER
Publicidad
Capítulos
