Honda BF40D Manual De Instrucciones página 584

14) Remove the 8 x 28 mm flange bolt and remove the height adjusting block.
15) Remove the 12 mm hex nut [small] from the steering bracket.
1
Loosen the 12 x 80 mm hex bolt, and remove the 12 mm hex nut [large], 14 mm wave washer, 12.2 x 23 x 16 mm
distance collar, 12 x 80 mm hex bolt and the 12 mm washer [small].
2
Remove the steering bracket and the 12 mm washer [large].
16) Check the steering handle bushings mounted on the steering bracket installation part of the tiller handle assembly
3
for wear, damage or deformation. Replace the bushings with new ones if necessary.
4
[2]
5
12 mm HEX NUT
[LARGE]
6
[1]
7
12 mm HEX NUT
[SMALL]
8
[10]
9
14 mm WAVE
WASHER
10
11
8 x 28
12
13
[9]
HEIGHT ADJUSTING
14
BLOCK
15
[8]
12 mm WASHER
[LARGE]
16
17
18
19
17) Remove the grip rubber and remove the 6 x 12 mm flange
bolt.
20
16-13
[3]
12.2 x 23 x 16 mm
DISTANCE COLLAR
[7]
STEERING HANDLE
BUSHING (2)
[1]
GRIP RUBBER
584
[4]
STEERING
BRACKET
[5]
12 mm WASHER
[SMALL]
[6]
12 x 80 mm
HEX BOLT
6 x 12