Publicidad
USE
Operation
When the appliance has been prepared correctly and you are
ready to cook, you can set a temperature from 60°C to 230°C
for each grill plate (upper and lower) independently (using
the thermostat dials 12 and 14).
Press the start/stop button and the ON light will come on.
The appliance takes some minutes to heat up depending
on the set temperature. When the thermostat reaches the
required temperature, the appliance emits a beep, and is
ready to use. "READY" appears on the display.
The temperature can be changed at any time during cooking,
depending on the type of food being prepared.
Timer function
When "READY" appears on the display, select the cooking
position (see the section "Cooking Position"), then place
the food on the plates. The cooking time can be selected by
pressing the timer buttons (9 and 10); in this case, at the end
of the cooking time, the appliance switches off automatically
and "END" is displayed. To switch the appliance on again,
press the start/stop button (8). When the food is cooked, if
you have not selected a cooking time, switch the appliance
off by pressing the start/stop button or turn the thermostat
dials (12 and 14) to the off position.
Please note: if no time is selected, the appliance will
turn off automatically after 90 minutes of operation.
Sear function
This feature heats the upper and/or lower plates to a higher
temperature for a few minutes. It is ideal for quickly searing
foods at the beginning of cooking (ideal for thick meat).
Press the start/stop button, then preheat the plates by
pressing the sear buttons (11 and 13). While preheating,
"SEAR" flashes on the display. When the thermostat reaches
the required temperature, the appliance emits a beep and
"sear" appears on the display. Put the food on the plates
immediately. The cycle is complete in a few minutes, and
"sear" disappears from the display.
Please note: This function can be used once only
in every 30 minutes. After the cycle, if you press the sear
function within 30 minutes, "sear" will flash on the display,
then go off. The operation cannot be set on the control.
Waffle mode (only if you have accessory waffle plates)
-
Insert the waffle plates (15c/15d) as shown in
fig.1. Please note that in this case the plates are not
interchangeable and the position of each plate must be
as shown in figure 8.
15c
15d
-
Once the lower plate is inserted in the appliance,
appears on the display.
Turn the thermostat dials to the waffle setting
and press the start/stop button.
-
The appliance starts the preheating phase. When the
thermostat reaches the required temperature, the
appliance emits a beep, and is ready to use. "READY"
appears on the display.
-
Lightly grease the plates with melted butter
-
Add one dosing cup for each waffle area.
-
Spread the batter slightly and close the appliance.
-
Cook according to the time indicated in the recipes.
If you set the timer, three beeps will sound at the end of
the cooking cycle, the timer will disappear and "END"
will appear on the display; the appliance switches off
automatically. If you do not select a time, at the end of
the last waffle press the "start/stop" button to switch off
the appliance.
-
To cook additional waffles, simply add batter to the
lower waffle plate and follow the above steps.
28
Publicidad
