Publicidad
User Manual
Service
Troubleshooting
Error message
E1:
The computer receives no signal from the motor or the signal is
interrupted .
E2:
There is no connection between the power board and the computer
or the power board is defective .
E4:
The computer receives no signal during the BMI-BMR-Body Fat
Measurement test mode .
Solution: see "The computer display is not working" .
The computer display is not working
• The computer might not be getting power. Check all connections and
cables .
• If all connections are in order and you still have no read out on the display
please contact your local ENERGETICS-dealer .
Heart rate (PULSE) is incorrect or not displayed at all.
Monitoring via the hand pulse sensor:
• Check if your hands have proper contact with the sensors. Both hands have
to be placed on the sensors simultaneously . There might be a slight delay
before the read out appears .
• Check all cable connections.
• Try moistening your hands slightly if they are very dry.
All manuals and user guides at all-guides.com
Monitoring via the chest strap (optional):
• Not all available chest straps are compatible with the E-204. Check if your
chest strap runs on a frequency of between 5,4 – 5,7 Hz .
• The battery of the chest strap is too weak and needs replacing.
The computer has shut down
In rare cases the computer might shut down, mainly because of sudden
changes in the electrical current or static discharge . Normally the E-204
restarts on its own .
Should this not occur restart the computer by pulling the power plug, wait a
few seconds then reinsert it .
Care
Take care that to avoid any moisture penetration . Clean the computer with a
lightly dampened cloth . Do not use abrasive cleaning solutions .
Maintenance
There is no need for special maintenance . Regularly check that all bolts and
connections have a tight fit . Exchange any defective parts immediately . For
assistance contact your local ENERGETICS-dealer .
Publicidad
Capítulos
